Why do flat roofs leak more often than sloped roofs?
No roof is truly flat. A good low-slope roof has a gentle pitch toward drains or gutters. But water still moves slowly, so it sits against seams, flashings and edges much longer than it would on a shingle roof. Every small gap gets tested with every rain.
In Hicksville, flat roofs are common on rear additions and enclosed porches behind ranches and Capes, and on the warehouses and offices of the business district. Buildings in the Hicksville Industrial Area rely almost entirely on large low-slope roofs.
What are the most common causes of flat roof leaks?
| Problem | What happens |
|---|---|
| Ponding water | Low spots hold water that ages the membrane and finds weak seams. |
| Seam failure | Adhesive or tape lets go, especially on older rubber roofs. |
| Clogged drains | Leaves and debris block the only way water can leave. |
| Edge and wall flashing | Water gets in where the roof meets a wall or parapet. |
| Punctures | Foot traffic, tools and equipment servicing damage the membrane. |
| Freeze-thaw | Water in small cracks expands in winter and opens them wider. |
How do the main flat roof materials compare?
Each material needs its own repair approach:
- EPDM rubber: black sheets, glued or ballasted. Leaks often at seams; repaired with compatible patches and tape.
- TPO and PVC: white or gray sheets with heat-welded seams. Repaired by hot-air welding new material.
- Modified bitumen: asphalt-based rolls in layers. Blisters and cracks are cut out and covered with new layers.
Asphalt-based tar doesn't bond to EPDM or TPO and can damage them. Using the wrong patch makes the real repair harder.
Where are flat roofs found in Hicksville?
On the residential side, flat and low-slope roofs are most common over rear additions, enclosed porches, sunrooms and attached garages. These were often built years after the house, sometimes with a different contractor and materials, and they're tied into the main house at a single wall joint that depends entirely on good flashing.
On the commercial side, flat roofs cover the warehouses and multi-tenant buildings in the business district, the stores and offices along North Broadway and Bethpage Road, and the apartment and mixed-use buildings near the train station. Commercial roofs carry rooftop units, exhaust fans and long seams, so regular inspections matter even more. Whether it's a porch or a warehouse, the same basics apply: keep drains clear, watch for ponding and fix small splits before winter.
If you're not sure what kind of membrane is on your porch or addition, take a close-up photo of the surface and the edge. We can usually identify it from that and bring the right patch materials on the first visit.
How do you keep a flat roof from leaking?
- Clear drains and scuppers each spring and fall.
- Check for ponding a day or two after rain.
- Limit foot traffic and use walk pads near equipment.
- Inspect seams and wall flashing every year.
- Fix small problems right away before water reaches the insulation.
Take pictures of standing water a day after rain. They show us exactly where drainage needs improving.
When a leak does appear, our guide to flat roof leak repair explains the fixes, and flat roof leak repair in Heitz Place covers the older buildings near the train station. Homeowners can also start from our Hicksville roof leak repair site.
Frequently asked questions
How long should water sit on a flat roof?
Water should drain or evaporate within a day or two. Longer is ponding, which shortens roof life.
Can a flat roof be repaired in winter?
Some repairs can, depending on material and temperature. Others need warmer weather, so a temporary fix may come first.
Why does my porch roof leak at the wall?
The joint between a porch roof and the house needs flashing tucked behind the siding. Caulk-only joints often fail.
How often should a commercial flat roof be inspected?
Twice a year, usually spring and fall, plus after major storms.